Free In-Home EstimateLocally Owned & OperatedOne Crew, Start to FinishWritten Price Before Work Starts
Crystal River, FL · Garage Floor Coatings

Garage Floor Coatings in Crystal River, FL

The money floor of the house — ground, repaired, and coated to hold in Gulf heat.

Wide concrete floor with a polished finish

Garage floor coating is the core of what we do. A two-car garage in Crystal River usually runs 400 to 500 square feet, and the job is the same every time: test the slab for moisture, grind it open, repair the cracks, and build the coating up in layers.

The system matters less than the prep, but it still matters. Full flake hides slab flaws and adds grip. Polyaspartic cures fast and holds color at the door line. A solid color suits a workshop. The pages below walk each one through.

What moves the price is the slab. A flat, dry slab coats fast. A slab with a peeling kit floor, deep cracks, or a high moisture reading needs work first — and that work is priced in writing before we start.

Why garages peel here

They peel for three reasons, and all three are preventable. First, the slab was never ground — a coating rolled onto sealed or dusty concrete has nothing to hold. Second, moisture pushed up from below and lifted the film. Third, thin kit epoxy softened under hot tires and lifted in crescents. Our install is built to answer all three: grind, test, and build thick.

  • Diamond grind to an open profile — never acid etch alone
  • Moisture test on every slab, primer where the reading calls for it
  • Full-build system with a hard, UV-stable topcoat

Garage work, recent

The same Crystal River garage floor before coating
Finished full-flake garage floor in Crystal River
BeforeAfter

Two-car garage, full-flake system

440 sq ft · Final price $3,450

The slab had oil spots at both bays and a hairline crack at the door. We ground it open, filled the crack, and ran a full-flake system with a sun-stable topcoat.

Representative job — an example of the work and pricing on this site, replaced with verified job records as they close.
The same Inverness garage floor before coating
Flake finish carried from a garage into a lanai in Inverness
BeforeAfter

Garage and lanai in one finish

660 sq ft · Final price $5,200

One finish ties the three-car garage to the screened lanai out back. The slab tested damp near the door, so a moisture primer went down first.

Representative job — an example of the work and pricing on this site, replaced with verified job records as they close.
Polyaspartic garage floor in Spring Hill

Polyaspartic garage, back fast

440 sq ft · Final price $4,150

A working garage that could not sit empty for days. The fast-cure system went down in one visit and the cars were back the next day, per the written schedule.

Representative job — an example of the work and pricing on this site, replaced with verified job records as they close.

Get a Free Estimate in Crystal River

Tell us about the floor. We call back with a time to come look — the written price comes after the in-person look, before any work starts.

Rather talk? Call (352) 555-0162.

Questions we hear

Why do you test for moisture before coating?

Ground moisture pushes up through the slab. A coating over a damp slab can blister and lift months later. The test tells us whether a moisture primer goes down first — in Citrus County, with a high water table, we test every floor.

What happens if the test reads high?

We prime with a moisture barrier first. It adds cost and a step, and it is the step that keeps the floor down. We would rather tell you that at the estimate than patch a floor later.

How long does a garage take?

Most two-car garages take one to two days of work, depending on the system and the slab. Polyaspartic topcoats cure fast, so cars are usually back the next day. Your written schedule comes at the estimate.

Can you coat over my old epoxy or paint?

Only after it comes off. We grind the old coating away and start from bare concrete. Coating over a peeling layer just gives the new floor something loose to hold onto.

Is it slippery when wet?

Flake texture gives the floor grip, and we add anti-slip grit where the floor gets wet — lanais, pool decks, and garage entries. A smooth gloss finish belongs indoors, not by a pool.

Estimate Calculator

Pick your floor and its size. The range updates as you go.

Add-ons your floor may need

Your planning range —

Every floor is different. Slab condition moves the final number more than size does.

These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.

Call (352) 555-0162 Estimate Calculator